The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver).
Product Id: 11742
Your Price:
€5.18
Shipping Weight: 10 g
EasyDriver requires a 7V to 30V supply to power the motor and can power any voltage of stepper motor. The EasyDriver has an on board voltage regulator for the digital interface that can be set to 5V or 3.3V. Connect a 4-wire stepper motor and a microcontroller and you've got precision motor control! EasyDriver drives bi-polar motors, and motors wired as bi-polar. I.e. 4,6, or 8 wire stepper motors.
This is the newest version of EasyDriver V4. It provides much more flexibility and control over your stepper motor, when compared to older versions. The microstep select (MS1 and MS2) pins of the A3967 are broken out allowing adjustments to the microstepping resolution. The sleep and enable pins are also broken out for further control.
Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC.
A4988 is a complete microstepping motor driver with built-in translator for easy operation. The product is available in full, half , 1/4, 1 / 8 and 1 /16 step mode to operate bipolar stepper motors of an output drive capability of up to 35 V and ± 2 A.
DRV8825 can drive high torque motor, compared to A4988 it can stand for up to 45 VDC power supply, output 2.5 A per phase and supports full, half, 1/4th, 1/8th, 1/16th and 1/32th microstepping.
TMC2208 is an ultra-quiet two-phase stepper motor drive chip, continuous drive current 1.4A, peak current 2A, voltage range 5.5V-36V, 3-5V logic, 256 subdivision. This is revision 2.0.
The TB6600 Stepper Motor Driver is an easy-to-use professional stepper motor driver, which could control a two-phase stepping motor. It is compatible with Arduino and other microcontrollers that can output a digital pulse signal. TB6600 stepper motor driver has a wide range power input 9~42VDC power supply. It is able to output 4A peak current, which is enough for the most of stepper motors.
Bipolar stepper motor, 1.8°step angle, 28 Ncm holding torque, 1.3A rated current, dimensions 42x42x34 mm, 22 mm shaft (5 mm diameter), comes with 1m lead wires.
This is high torque Nema 17 stepper motor with 1.8° step angle (200 steps/revolution). Each phase draws 2A, allowing for a holding torque of 59Ncm(83.6oz.in). It's good ideal for 3D printers, as well as CNC and robotics applications. The motors are supplied with a 1 metre long power cable with a 4-pin Dupont female connector already fitted.
This motor is lighter and shorter than a typical NEMA17 motor, however it produces almost as much torque. It is suitable for driving geared or direct extruders and is used on E3D's Titan extruder.
This is popular geared Nema 17 stepper motor with a medium body and torque. It has an integrated planetary gearbox with a 5.18:1 gear ratio, the resolution reach 0.35° step angle. It's a good solution in applications that need very low rotation speeds and/or lots of torque.